1260 AUTOMATIC TRAVERSE
Characteristics
Technical specifications
Accessories
View enlarged image 		Miscellaneous Spare parts
  The 1260 Automatic Traverse functions the same as the 1250 Automatic Traverse but occupies a larger footprint for heavier winding applications. It is designed to interface with the 1400 Bobbin Winders to automatically lay the wire onto the work piece by traversing back and forth relative to the wire diameter and speed of the Bobbin Winder. This eliminates the operator from having to hand lay the wire onto the work piece. The 1260 Automatic Traverse is physically mounted on the 1417 Baseplate and located to the right and slightly behind the Bobbin Winder. The wire is fed from behind the Traverse, over the Wire Support Arm onto the work piece. The wire tension is controlled by a dereeler.

CHARACTERISTICS

1. Easy to operate.
2. Exact layer winding using microprocessing technology.
3. Precision stepper motor.
4. Precision pitch and length control.
5. Programs stored in internal, non-volatile memory.
6. Built in winding programs.
7. Up to thirty user defined home positions.
8. RS-232 computer interface capability.
9. Multiple bobbin capability.

Built in programs allow several winding modes including layer winding, multi-home, variable pitch and variable layering.

back to top

 

TECHNICAL SPECIFICATIONS
Controls/Status Lights Power, Jog Right and Left, Initialize home positions, Go home (right and left), Manual and Auto stops, Pitch Settings, Length Settings, At Home, Manual vs. Auto Mode, will move right/left, Over speed warning, Full-half step mode, Normal/fine pitch, program mode.
General
Motor Type Stepper motor control
Traverse Length 24 inches
Length Increments settable to .001 inch
Carriage Speed 1.0 inch per second
Fine Pitch Mode .0001 - .0999 in/rev
Regular Pitch Mode .001 - .999 in/rev
Winder Sensor Photoelectric pick-off
Power Requirements 117V 50-60 Hz, 400 VA
Dimensions L x W x H = 36” x 18” x 15”
Weight 60 lbs
Wire Guide Max Guide #5 awg

back to top

 

1260 Automatic Traverse Accessories


1428 Wire Guide Assembly

 Mounts directly to the vertical post on the carriage assembly to guide wire from the dereeler to the work piece. The adjustable wire guide consists of two high strength nylon pulleys and a wire grip.

1440 Wire Tube

 A small diameter tube that is mounted in place of the bottom pulley on the Wire Guide Assembly to allow fine wire to be positioned close to the work piece for better layering control.


1443 Guide Rail

  Used with the 1444 Holders to provide a platform to mount several 1428 Wire Guide Assemblies for multiple bobbin winding applications. The Guide Rail replaces the vertical mounting post on the carriage assembly of the Traverse.

1444 Holders

 Multiple Holders can be mounted to the 1443 Guide Rail allowing multiple 1428 Wire Guide Assemblies to be installed, to wind several bobbins at the same time.

Dereelers

 Provide tension on the wire during the winding process. A spool of wire is placed on the base of the dereeler and the wire feeds through a series of spring tensioning rings and pulleys. A variety of dereelers are available according to the range of wire size and spool diameter.

Wisker Disks

 Placed on top of wire spools, they work as a pre-tensioner and to keep the wire at a controlled path.

back to top

home | site map | contact us | about us
1201 Series | 1400 Series | 1250 ATL | 1260 ATL